there ready

[brianambrose17]

The turbo charged jig's are ready. I do accept pay pal, money orders and checks. These jig's sell for $40.00. my mailing address is.
Brian Ambrose
2912 51st ave terr w
Bradenton,FL.34207
My e-mail is [email protected]
My phone number is 941-592-5978.
Orders your today. If you buy it and don't like it I will buy it back if it is in good shape still. You have nothing to lose.

[hotcool35]

can i be shown a picture?!

[mfaccone]

I've seen this thing...
I can see where it does make the axle sit perfectly horizontal to the bottom of the chassis... and faster to install... but how the heck could it possibly make it perfectly square to the guide? You claim its better than the pin jigs.. but I doubt it since I have seen stamped chassis a full 1/16 to 1/8 inch out of square to the guide yet perfectly to the bottom of the chassis.
I think I would prefer spending the extra money for a full sized jig that works the whole chassis and takes longer than to do the job half way. sorry